- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
SCSI Controller
Comspec: SA2000
Connection: Zorro II |
Full length Zorro II SCSI card, which supports autobooting if Kickstart 1.3 is present. It has a 50pin internal SCSI header and what appears to be a DB25 external SCSI connector. It does not appear to adhere to the Commodore RDB (Rigid Disk Block) standard as it will not boot from a FFS volume. It has to be setup similar to the old A2090a if you wish to use FFS. The card uses the WD33C93-PL SCSI chipset made by Western Digital, has a header for an LED and one jumper to enable or disabled autobooting (JP2, Labelled Kickstart 1.3 or 1.2).
It is unlikely that this card will be compatible with Kickstart 2.04 or later and certainly does not work with the A2620 and A2630 accelerator cards.
Contributions to this page by:
Paul Gable
Letzte Änderung des Artikels: 2009-01-29 10:19
Revision: 1.0
You cannot comment on this entry