- Startseite
- Alle Kategorien anzeigen
- Modelle und Clones
- A1000 Turbokarten
- A1200 Turbokarten
- A2000 Turbokarten
- A3000 Turbokarten
- A4000 Turbokarten
- A500 Turbokarten
- A600 Turbokarten
- Bridgeboards & Emulatorkarten
- CD32 Turbokarten
- CDTV Turbokarten
- Custom Chips
- Digitiser & Framegrabber
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Grafik (non RTG) & Videokarten
- Grafikkarten (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Tastaturen & Adapter
- Kickstart Umschalter
- MIDI Geraete
- versch. ZORRO Karten
- verschiedene Hardware
- Monitore
- Netzwerk Karten
- Prozessoren
- RAM Erweiterungen
- Scanner
- SCSI Controller
- Sound Karten
- Soundsampler
- Bandlaufwerke & Backup
- Time Base Correctors
- Tower Kits
- Zorro Erweiterungen & Busboards
- Mystery Corner
- Suche über Anschluss
- Sitemap
Netzwerk Karten
ASDG Inc.: EB920 / LAN Rover
Connection: Zorro II |
Front
Back
LAN Rover with manual and box
Hi Res Version, Front - 314K
Hi Res Version, Back - 293K
Hi Res Version, LAN Rover with manual and box - 293K
Closeup of left side - 616K
Closeup of right side - 669K
Image of backplate - 117K
Type | Ethernet |
10Base2 (BNC & Coax, ThinNet): | Yes |
10Base5 (AUI & Coax, ThickNet): | No |
10BaseT (RJ45 & UTP): | No |
100BaseTX (RJ45 & UTP): | No |
SANA-II Driver: | Yes |
MNI Driver: | Yes (z2-dp8390.mni) ** See Below |
Other Driver: | No |
Full length Zorro II network card. The card has a soldered jumper to change the interrupt from 2 to 6. Also this card does not have a MAC address by default, so this must be set in the TCP/IP stack or using a piece of software called s2util . At least one of the ROM sockets is for adding a ROM containing the MAC address, the other is probably for adding a boot ROM. The early cards were called LANRover but later had to be renamed due to legal reasons.
** When using MNI drivers you must set the correct options for the MNI driver. If you have the interrupt jumper set to 2 then you must use "INT=2" if it is set to 6 then you must use "INT=6". You must also specify a MAC address in software if your particular card does not contain a MAC ROM.
Contributions to this page by:
Erik Inge Bols?, Takahasi Kasiko
Letzte Änderung des Artikels: 2009-01-26 21:20
Revision: 1.0
Kommentieren nicht möglich