- Startseite
- Alle Kategorien anzeigen
- Modelle und Clones
- A1000 Turbokarten
- A1200 Turbokarten
- A2000 Turbokarten
- A3000 Turbokarten
- A4000 Turbokarten
- A500 Turbokarten
- A600 Turbokarten
- Bridgeboards & Emulatorkarten
- CD32 Turbokarten
- CDTV Turbokarten
- Custom Chips
- Digitiser & Framegrabber
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Grafik (non RTG) & Videokarten
- Grafikkarten (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Tastaturen & Adapter
- Kickstart Umschalter
- MIDI Geraete
- versch. ZORRO Karten
- verschiedene Hardware
- Monitore
- Netzwerk Karten
- Prozessoren
- RAM Erweiterungen
- Scanner
- SCSI Controller
- Sound Karten
- Soundsampler
- Bandlaufwerke & Backup
- Time Base Correctors
- Tower Kits
- Zorro Erweiterungen & Busboards
- Mystery Corner
- Suche über Anschluss
- Sitemap
Netzwerk Karten
Individual Computers: XSurf
Connection: Zorro II |
Hi Res Version of Front - 157K
Hi Res Version of Back - 148K
Type | Ethernet |
10Base2 (BNC & Coax, ThinNet): | Yes |
10Base5 (AUI & Coax, ThickNet): | No |
10BaseT (RJ45 & UTP): | Yes |
100BaseTX (RJ45 & UTP): | No |
SANA-II Driver: | Yes |
MNI Driver: | Yes (z2-dp8390.mni) |
Other Driver: | No |
Full Length Zorro II ethernet card which is also compatible with all the major Zorro busboards. The X-Surf card itself acts as a Bridgeboard between the RealTek ISA card which is soldered to the board and the Zorro bus. The card is media autosensing, and includes a 16Kb buffer. The card includes 2 "Clock Port" connectors for expansions such as the Hypercomm, a 26pin expansion module, 1 x 2.5" IDE Connector and 1 x 3.5" IDE connector for up to four IDE drives. The IDE connectors on this card, should be considered as a freebie because they do have certain limitations. They do not support autobooting, so you cannot boot from any devices connected to the controller and they can issue only one IORquest at a time and are therefore not suitable for certain applications such as CDWriters. Hard Drives, CD-ROMs, ZIP Drives etc, should work without problems. It is extremely important that do you DO NOT use 2.5" drives which exceed 300mA power consumption. The traces on the card are rated at a maximum of 300mA. If you use a device on the 2.5" connector which exceeds this, then you risk burning the traces. This limitation does not apply to 3.5" devices because they do not draw their power from the IDE cable, but use a separate power connector instread.
Contributions to this page by:
Erol Ismael, Pascal Rielland, Petr Voralek, Sebastian (Exin), Stephan Neise
Letzte Änderung des Artikels: 2009-01-26 21:29
Revision: 1.0
Kommentieren nicht möglich