- Startseite
- Alle Kategorien anzeigen
- Modelle und Clones
- A1000 Turbokarten
- A1200 Turbokarten
- A2000 Turbokarten
- A3000 Turbokarten
- A4000 Turbokarten
- A500 Turbokarten
- A600 Turbokarten
- Bridgeboards & Emulatorkarten
- CD32 Turbokarten
- CDTV Turbokarten
- Custom Chips
- Digitiser & Framegrabber
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Grafik (non RTG) & Videokarten
- Grafikkarten (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Tastaturen & Adapter
- Kickstart Umschalter
- MIDI Geraete
- versch. ZORRO Karten
- verschiedene Hardware
- Monitore
- Netzwerk Karten
- Prozessoren
- RAM Erweiterungen
- Scanner
- SCSI Controller
- Sound Karten
- Soundsampler
- Bandlaufwerke & Backup
- Time Base Correctors
- Tower Kits
- Zorro Erweiterungen & Busboards
- Mystery Corner
- Suche über Anschluss
- Sitemap
SCSI Controller
Advanced Storage Systems: Nexus
Connection: Zorro II |
Nexus, Front
Nexus, Back
Hi Res Version, Nexus, Front - 395K
Hi Res Version, Nexus, Back - 359K
Closeup of Nexus, Front left side - 576K
Closeup of Nexus, Front right side - 632K
Closeup of Nexus, Back right side - 571K
Jumper Diagram - 1K
Full length Zorro II card which can take up to 8MB of RAM on the card in the form of 30pin SIMMs. The card supports 1MB, 2MB and 4MB SIMMs. There is enough space to mount a hard drive directly onto the card, however the card has no provision for supplying the drive with power. The power must come from one of the PSU connectors. The card is very sensitive to how drives are connected and configured. Each device which is attached to the Nexus card must use the lowest available SCSI ID. For example, if you only have one hard drive connected, then this should be set to ID 0, otherwise you will have problems autobooting and detecting devices. The card has an internal 50pin connector and an external 25pin connector.
Jumpers
For the memory test program to work correctly, you must have the memory test jumper set. Also for the card to support Auto Booting, the auto-booting jumper should be set.
Note: The Nexus could NOT handle all sorts of SIMM modules.
Following SIMM types (1Mx9) seem to work correctly:
HYM91000S Siemens
MC421000A9A/A9B NEC
MSC2312AYS9/AKS9 OKI
THM91000AS/AL Toshiba
Don't use SIMMs 1Mx8! These ones don't work properly.
Contributions to this page by:
Andreas C Schmidt, Gerald Yuen, Takahasi Kasiko
Letzte Änderung des Artikels: 2009-01-27 11:22
Revision: 1.0
Kommentieren nicht möglich