- Startseite
- Alle Kategorien anzeigen
- Modelle und Clones
- A1000 Turbokarten
- A1200 Turbokarten
- A2000 Turbokarten
- A3000 Turbokarten
- A4000 Turbokarten
- A500 Turbokarten
- A600 Turbokarten
- Bridgeboards & Emulatorkarten
- CD32 Turbokarten
- CDTV Turbokarten
- Custom Chips
- Digitiser & Framegrabber
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Grafik (non RTG) & Videokarten
- Grafikkarten (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Tastaturen & Adapter
- Kickstart Umschalter
- MIDI Geraete
- versch. ZORRO Karten
- verschiedene Hardware
- Monitore
- Netzwerk Karten
- Prozessoren
- RAM Erweiterungen
- Scanner
- SCSI Controller
- Sound Karten
- Soundsampler
- Bandlaufwerke & Backup
- Time Base Correctors
- Tower Kits
- Zorro Erweiterungen & Busboards
- Mystery Corner
- Suche über Anschluss
- Sitemap
SCSI Controller
Amitrix: SCSI-TV / SCSI-TV/570
Connection: Andere |
SCSI-TV installs easily in the expansion port accessible at the rear of the CDTV or A570, without opening the case. A 2.5 inch Quantum GO drive may be mounted on the SCSI-TV circuit board and an external connector can connect to hard drives, scanners, and tape backups, to a total of seven devices.
SCSI-TV supports the Amiga AUTOCONFIG(TM) standard, providing autobooting capability with Rigid Disk Block support, as well as the SCSI-direct protocol allowing many backup programs to use SCSI tape drives. True DMA allows for fast data transfer rates and low CPU overhead
Dimensions: Width 3.1 inches, Length 6.25 inches
SCSI-TV for the CDTV protrudes 1.75 inches out the back of the CDTV,
and includes a black endcap for the unit. SCSI-TV/570 for the A570
extends approximately 5 inches out the back of the A570, and includes a
white end cap for the unit to match the A570.
Power consumption:
SCSI-TV alone draws about 12 milliamps, a GO-drive will draw a maximum
of about one Amp on startup and about half that during operation.
Typical for Quantum 2.5" GO-drive:
Idle 1.65 Watts (0.33 Amps)
Running 2.20 Watts (0.44 Amps)
Spinup 5.50 Watts (0.90 Amps)
Connectors:
50-pin internal and 25-pin external connectors.
The internal connector is a 2mm connector after passing through a 0.1 inch IDC header.
The external connector is a standard female DB-25.
An FAQ for this board can be found on Amitrix's website.
Contributions to this page by:
Erik Inge Bols?
Letzte Änderung des Artikels: 2009-01-27 11:26
Revision: 1.0
Kommentieren nicht möglich