- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
A500 Accelerators
ID #3108
Harms Computertechnik: Animate II
Connection: CPU Socket |
Processor: | 020@14Mhz |
FPU: | Optional 68881 or 68882 @ 14Mhz or 16Mhz (PGA) |
MMU: | None |
Max Ram: | None |
Ram Type: | Does not support the addition of memory |
An accelerator which plugs into the CPU socket of the A500 and A1000. The accelerator also has a 68000 fallback mode for compatibility with old software.
There MUST BE a wire from Pin12 of U6 to Pin9 of U7. If you have an accelerator board without a coprcessor, you have to connect Pin18 of U4 with Pin22 of the 64pin socket, wich connects the board to the AMIGA.
Contributions to this page by:
Mario Misic
Letzte Änderung des Artikels: 2009-01-25 13:43
Revision: 1.0
Average rating: 0 (0 Votes)
You cannot comment on this entry