- Home
- Show all categories
- Models & Clones
- A1000 Accelerators
- A1200 Accelerators
- A2000 Accelerators
- A3000 Accelerators
- A4000 Accelerators
- A500 Accelerators
- A600 Accelerators
- Bridgeboards & Emulator Cards
- CD32 Accelerators
- CDTV Accelerators
- Custom Chips
- Digtizers & Framegrabbers
- Flickerfixer & Scandoubler
- Floppy Controller
- Genlocks
- Graphics (non RTG) & Video Cards
- Graphics Cards (RTG)
- I/O Karten
- IDE Controller
- ISDN & Modem
- Keyboards & Adapters
- Kickstart Switchers
- MIDI Devices
- Misc ZORRO Cards
- Misc. Hardware
- Monitors
- Network Cards
- Processors
- RAM Expansions
- Scanner
- SCSI Controller
- Sound Cards
- Soundsampler
- Tape Drives & Backup
- Time Base Correctors
- Tower Kits
- Zorro Extenders & Busboards
- Mystery Corner
- Browse by Connection
- Sitemap
Misc. Hardware
Commodore: A520
Connection: Video Socket (Amiga 23pin) |
Picture showing the top of the device
Picture showing the bottom of the device
Picture showing the back of the device
Picture showing the side of the device
Hi Res Version, Image 1 - 372K
Hi Res Version, Image 2 - 359K
Hi Res Version of Top - 60K
Hi Res Version of Bottom - 73K
Hi Res Version of Side - 39K
Hi Res Version of Back - 28K
Image of Manual - 15K
Image of Box - 27K
The A520 was a TV modulator that was generally supplied with the A500 series of machines but can be used with almost any Amiga. It converts the RGB port for use with a TV by supplying an RF (aerial lead) connector. The two audio outputs were also attached the modulator for sending the audio signals down the RF lead. The L H switch is for switching between two slightly different frequencies in case it was causing or receiving interference from another device such as a VCR.
Contributions to this page by:
Dagfinn Olsen, RiWa & Friends
Letzte Änderung des Artikels: 2009-01-26 16:42
Revision: 1.0
You cannot comment on this entry